Come to find out with bridge plugged into the v2 cam it temps go up to 107° or higher. It’s only stable for about an hour at this temp. Higher output power brick, different V2 camera or shorter cable does nothing. The only thing that seems to be working is a foot long USB extension cable from the cam to the bridge so the heat from the camera doesn’t heat up the bridge. In doing this the bridge temp gets no higher then 85.5° and I haven’t had the first drop out. I’ve checked and all my V2 temps are about the same temperature. Pictures taken of the V2 in a 73° room thats been going for 24 hours with the USB extension to the bridge. So it looks like the camera heat was making the bridge over temp and disconnect all the Sensors. I even had the bridge report a dead battery on one of my contact Sensor that completely went away after doing this setup. Keep in mind I’ve only had the sensor starter kit for about two weeks and this is the longest it’s gone without a gitch. Everything factory but the USB extension.
IttMVIMG_20200501_222205|375x500 15883860200388109029696659295630|375x500
2 Likes