Wyze Vacuum - Designated Blind Spots (for mirrors)


Your submission has been merged (see below). For future reference, please search the #wishlist and #roadmap categories before submitting a new #wishlist topic. Use these links to search each category:

Search Wishlist (enter your search word/s after #wishlist in the search box)
Search Roadmap (enter your search word/s after #roadmap in the search box)

Please read through How to Use the Wishlist and How to Read the Roadmap.

You can now hop on over to the merged topic (see below) and VOTE for it. For your vote to count, you must click the VOTE button at the top of the page.


Love the vacuum!

However: the LIDAR gets confused by floor length mirrors. It bounces back and the Wyze Vac may decide not to clean that area.

Would it be possible to add a rectangle for “clean this area blindly no matter what LIDAR says” similar to how you can create a red rectangle for a virtual wall? The device would just go in slowly and bump its way through.


A post was merged into an existing topic: Wyze robot vacuum map editing