Hey guys, I just got back from a trip to Colorado and went to setup my Thermostat and it was going good until I didn’t have a “C” wire on my old thermostat. But I did have a blue wire that wasn’t spliced.
Anyways I go thru the whole setup and I was told I had to many wires going to my Wyze thermostat and I needed to remove them. I didn’t have any of the wires it said I had in there. So after trying a few retries I decided to just skip. Boom my thermostat was on great now comes the time to check stage 1 heating and cooling. At first heating work then I tried cooling. That’s when all hell broke loose.
My Wyze thermostat starts clicking and I was like I for the night I will put my old thermostat on tonight and just use ac if needed. A/C doesn’t work with old thermostat I check all breakers inside outside unit checked in the attic the breakers in the air handler and fuse at control board. No A/C working.
So I rechecked everything and decide I will put my Wyze thermostat on again and see if it will work now my thermostat just turns on and clicks and resets into a long recurring start up, click, power off. Over and over. Please help out.