My Wyze Cam Pan died. No power at all. So I contacted wyzecam and they are sending me a replacement.
They said I don’t need to send the camera in for replacement so I decided to do an autopsy.
I found the the issue was that the camera apparently panned around without stopping until the internal cable from the USB port to the motherboard snapped.
I repaired it and it is working again but there is nothing to stop the camera from panning around.
When the camera starts, it tests the motors and it will just pan until the cable breaks again.
If I hold it with my hand, it will stop panning so there is an overload sensor in the motor but I can’t find anything inside to prevent the camera from turning indefinitely.