What is the ma drain per hour at five volts for the v2

[Omgitstony]

Would this help? Write up from last year.

@Omgitstony

OmgitsScience !
All using Samsung 5v2a charger to normal Wyze charging USB cords.

V2, IR off, continuous record, with bridge.

V2, IR on, continuous record, with bridge.

V2, IR off, continuous record, without bridge.

V2, IR on, continuous record, with bridge.

V2, IR off, continuous record, daisy chained to a V2, IR off, continuous record, with bridge.

And finally…

V2, IR on, continuous record, daisy chained to a V2, IR on, continuous record, with bridge.

Test setup is outlet>USB charger brick>meter>first USB cord>first V2 (sometimes with or without bridge, then second USB cable to second v2, with out without the bridge). There are infinite possibilities with combos to run but I just picked a handful. In the numbers provided I am looking at just the voltage and ampage, the others I think apply to more battery banks, if my knowledge is correct.

And

@Omgitstony

I just ran this setup for exactly 1 hour. (V2, supplied charging cord and 5v1a power brick, IR off, continuous recording, no event cloud recording, minimal live streaming only to verify settings.). The amps and volts stayed about what’s shown the whole time, unless I connected to Livestream then it spiked at about .450a usage I believe, then once connected it chilled out back around .300ish.

The below pic was taken right at one hour.

Watched the clouds pass.