MODERATOR NOTE:
Your submission has been merged (see below). For future reference, please search the #wishlist and #roadmap categories before submitting a new #wishlist topic. Use these links to search each category:
Search Wishlist (enter your search word/s after #wishlist in the search box)
Search Roadmap (enter your search word/s after #roadmap in the search box)
Please read through How to Use the Wishlist and How to Read the Roadmap.
You can now hop on over to the merged topic (see below) and VOTE for it. For your vote to count, you must click the VOTE button at the top of the page.
=======================
Every botvac that I have ever owned or researched has suffered from an inability to distinguish between the edge of a stair and a black bar printed on a carpet. After all this time I really had hoped that the botvac industry would have solved the false-cliff sensor problem without having to resort to using black tape over the sensor. Until they do I’d like to offer a suggestion.
Don’t get me wrong this is not a complaint post. I love this vac. It functions far better than my last one.
Apparently, like most / all (?) botvacs my Wyze Vac does great until it hits the black lines in the printed, short pile, carpet that covers my entire kitchen and entry way. At that point it goes berserk… even bucking up and down in a failed attempt to back up or rotate in place… completely unable to figure out how to escape the rug and it’s many imaginary cliffs!
My house has no stairs so the cliff sensors are not critical. Rather than request that a hardware “sensor off” switch be added why not just expand the existing “Virtual Wall” function to solve this problem?
Just drag a large box “wall” around the problem carpet followed by a pop-up requesting the choice of the box being assigned the task of functioning either as a regular “no go wall” or as a “ignore cliff senser” region?
Yes, I could certainly use the “virtual wall” to keep the vac out of the kitchen completely (which I have tried) but that defeats the purpose of a vac… kitchens can get messy.
This should be an easy “logic” switch in firmware… since I rather doubt that the existing system includes an option for the addition of a cliff sensor “hardware” switch.