Thermostat needs Heat and Cool independant schedules. Auto is useless!

I just got and installed the thermostat. Also, I just found out the schedule will not run without some hardware decoder setting being on in the app. Why can’t the app sync the schedule to the thermostat after you set up the schedule? Also, change the gas furnace testing picture to a vent and not say radiator.

Also in the install directions, my furnace had two wires going to the Y connection on the furnace, One for the air conditioner and one for the thermostat. Following your directions required me to hook both the Y wires to the C wire adapter causing both my air and heat to run at the same time. You needed to mention I needed to leave the red wire from the air conditioner on the control board. This caused me many issues.