Super excited just got the wyze thermostat and having issues.
Installed no problem with c adapter. Display worked. Etc.
Went to update and since then it won’t power up.
Does the thermostat have a small battery that allowed the setup and then died (and my wiring was wrong) or did something screw it up during update.
Here’s my wiring setup.
It’s a gas dual stage forced hot air and AC setup.
Old Thermostat had w2, g, w, y, and r/rc jumped.
Control board on furnace had r(red wire), c(white wire), w(white wire), w2(blue wire), g(green wire), and y(with a yellow and red wire together).
Attached the adapter accordingly and triple checked the connection.
Wired the new thermostat like this:
Red to rc
Yellow to y
White to w1
Blue to w2
Green to c
Any help is greatly appreciated!!!