Looking for some guidance or advice.
I have x7 cameras all on the latest beta. All working fine. I ordered x2 Sense starter kits, one bridge for the front of the house and one for the back. I have a few sensors on each bridge.
The problem I have however is that on the bridge at the back of the house. The sensors paired with it all keep going offline. When I connect into the camera they are being hosted on and go to “extended devices” the bride is greyed out, and if I tap the bridge option in there it says I need to connect a bridge first. So it’s as if the camera has lost the bridge.
I can fix this by rebooting the camera from within the app. After the reboot the bridge shows again and the sensors connect and work. Hours later it’s offline again.
The bridge in my other camera at the front of the house doesn’t do this.
The sensors are very close to this bridge, so I don’t think them going offline is linked to range or interference, it seems more likely it’s because the camera is losing the bridge.
I swapped the camera too, so the camera that was at the back hosting the bridge is now elsewhere in the house, and a different one is now at the back with the bridge. I suspected maybe the usb port on the back of the camera was faulty but the behaviour is the same in this other camera. So I don’t think it’s the camera.
Wondering if anyone else has had this issue? Any other suggestions?
As I mentioned I’m on the latest Beta app (Android) and the latest Beta firmware on all the cameras (V2s) the bridge is on 0.0.0.33.