I have a contact sensor on a screen door that fails to register a “closed” state at least once per week. As I travel for work, this is driving me absolutely batty.
Proximity - this is the closest of any of my sensors (3 contact, 1 motion), but the only one having routine issues.
Typical countermeasures - I have swapped the bridge between cameras, and also deleted/re-paired (most recently during the outage).
It happened again today when my dog walker showed up to take the pup out. Here I sit in an airport with yet another notification that the door has been open for 3+ minutes. Only once was it legit (when the magnet fell to the ground and became a cat toy).
I am curious if the nature of the screen door closer/damper is confusing the sensor. I adjusted the rate such that the door basically slams shut, but obviously to no avail. Has anyone else seen this and successfully remedied?