Return to Start position, response to out of sight

wyze-cam-pan
#1

Once the cam pan has followed an object say to the right and disappears what causes it to return to the center ? Is that a setting ? Is it possible for the camera to respond to something behind it or beyond the about 180 degree range of eye …. ? I’d like it to respond to a noise anywhere in the circle and begin to track. And after - return to start. Ideally both but the return to start is essential

Thanks

#2

Ok I see its supposed to go to the 4 way points at every 10 seconds - I have it set to default but its not moving - is that because I have motion detection set ? Ideally I just want it to scan and send a message if something is moving ….Is this an either OR option ???

#3

do you have motion detection zone on ? it is either ot with pan scan

#4

Also, make sure the Pan Scan icon button is lit green, indicating it is on. You may have set up the waypoints, but not actually turned on Pan Scan.

#5

Yes - we finally have all the right items enabled ( green ). And it now scans the sectors ( waypoints ) every 10 seconds and follows any motion… thanks !

1 Like