Power failure corrupted nand?

wyze-cam-pan

#1

I experienced a power failure and after the camera came back up, I could not get a picture. After much analysis I suspect the the configuration partition (mtdblock8) was corrupted. This a a quess, but if I am right, is there a procedure to restore the nand to “factory”? Any other thoughts?

Thanks,

Joe

 


#2

Search the support section (link at the top of the page) for Factory Reset. If that doesn’t work, you can flash the firmware (again, search the support section).


#3

I have tried both the factory reset and the firmware (https://www.wyzecam.com/forums/topic/flashing-your-wyzecam-pan-firmware/). No joy. That is why is suspect the nand.


#4

You’ll need to file a support ticket. I’m guessing they’ll probably replace the camera.


#5

@JDonth, I would suspect it is the Land if you have exhausted all options available.