Pan Scan only working in preview mode?

Hi, apologies if this is a silly question. I just recently picked up the Cam Pan. (previously had the original Cam). I’ve set up the pan scan in advanced/motion settings, and I’ve set the 4 way points. In the Preview mode, it cycles through the 4 waypoints as expected. However, after saving, I’m finding that when I look at the Live Stream, the camera is not scanning. I can use the buttons to move the camera, but I expected that it would scan on its own. Am I missing something?

Turns out to be my mistake. I needed to go to the ‘More’ option and enable them. Perhaps others have missed this too and More should be more conspicuous or display these options another one.