I have a Pan Cam that worked for about a week and then it got stuck on solid yellow. I followed the instructions here https://support.wyzecam.com/hc/en-us/articles/360031490871-How-to-flash-firmware-manually on how to Firmware Flash Manually using 126.96.36.199. I get to step 5 no problem “Wait for 3-4 minutes. The camera will reboot and change light status during this time.” but nothing happens no matter how long I wait. The light just stays the combined blue yellow solid LED. Tried switching out the cable but no luck. Anybody run into this issue and have any solutions?