Mounting motion sensirs

[SlabSlayer]

@Sam_Bam

#1 about the angle/distance and can walk under it without triggering it. That’s by design, not accident. Their intent was to not pickup the movement of pets. So, knowing this, you can install the sensor upside down and change the degree it “sees”.

The “pet” mode is mounting it upside down.

From:

Installing your Wyze Home Monitoring System

Courtesy of:

Motion v2/Home Monitoring Pet Detection

Welcome to the Wyze forum Peter. Measure your dog’s max height standing or sitting. If less than 3’, install motion sensor upside down at 3’: If taller than 3’, install sensor upside down at your dog’s max height plus around 8". Tip for pet owners: [88s57rzhi3]

Also:

Cant set motion detector to exclude pets

I have a staircase i want to cover with a motion detector. Its a point where there are 3 doors that allow access. I covered this with a single motion detector on my previous system. But that detector looked upward. I cannot get the wyze motion detectire to ignore small pets no matter where iocate it. Even my 5 pound Chihuahua triggers an alarm. How do these detectors work? Do they look up equally as down? What is the angle of coverage. Pets setting off an alarm is not a good system. I n…