Just create a dry contact sensor

[jeffsuber]

If you create a dry contact sensor, users can disconnect the alarm output of their home alarm systems, and connect to the dry contact. They could then get an alarm from their old alarm system (That is already connected to all the alarm points in the house) that has not been under alarm contract because it’s too expensive.

[johnsmith]

You should make this a wishlist item.

[Seapup]

General use contact sensors for Wyze Sense Hub / Home Monitoring

I would love to have a simple Wyze contact state sensor! Application: I currently have an older alarm system with N/C mag switch sensors having screw terminals, that I am upgrading. I have installed the Wyze Sense Hub + Home Monitoring service, etc. I would love to have a Wyze sensor I could connect to an existing magnetic switch to signal the switches’ state. In my existing system, multiple windows in some rooms are wired and monitored with their mag switches connected in series, resultin…

Open Wyze sensor

Remove the magnetic reed switch and replace it with screw terminals so that and sensor can be connected that would complete the simple circuit. I could rip an existing on open and solder the wires myself but a finished product would be better. Examples of other sensors would be a disconnected magnetic reed switch that could then be flush mounted in doors or other things that open/close. Shock sensors that complete a circuit when they are hit. Water sensors that would complete the circuit when wa…