“Ignore gross Light changes”

I’ve led a number of folks to buy Wyze cams. But the common complaint is that when their connected lights turn off or on, they get a Wyze alert. When 60 or 70% of the pixels all report change, it’s likely a lighting change.
Add a lighting change detect threshold slider and a toggle for enable/disable and I’ll bet you will make a lot of people happy.
Sensitivity is the minimum that has to change to trigger. Lighting detection is a ceiling, where anything over that is ignored.

A post was merged into an existing topic: Motion Detect - Light Switch Detection

Please hop on over there and VOTE for it. For your vote to count, you must click the VOTE button at the top of the page.