Default position (after restart/power cycle)

wyze-cam-pan

#1

Is there a way to change the default position that the camera starts at, after a power cycle/restart? We’ve had a few brown outs here and each time i’ve found the camera facing the wall. I’d like to make sure the camera is always pointing correctly, even after a power cycle.


#2

Anyone ??? Bueller ???

 

 


#3

damn. left hanging for two weeks. It’s a good question since I have a similar annoyance.


#4

The waypoint position selected and saved will become the new home position. You can set 4 waypoint positions but the one selected before clicking “save” will be the new home position.

If you don’t like the cam going back to any home position after 15 seconds, then :

  • turn on both "Motion detect" and "Pan scan" together
  • turn both off
Then you can pan the cam to any position and it will stay there without going back to home position after 15 seconds.