I bought a Wyze Starter kit and successfully installed it on a virtual machine (VirtualBox) on a Linux host. Virtual macine runs Home Assistant:
Bridge is installed and LED blue
Motion sensor is installed
Contact sensor 1 is installed
Contact sensor 2 doesn’t show a MAC address in Home Assistant and the LED blinks 3 times every 10 seconds. However the sensor actually responds to open/close events. The ID in Home Assistant shows as ‘binary_sensor.wyzesense’. So it looks like this sensor is in some kind of ‘interim’ state.
How can I reset this sensor>
Are the LED status documented anywhere? What does it mean for the LED to blink 3 times every 10 sec?