There are many disadvantages to the Wyze Cam Outdoor though, you could also consider using “Low Voltage Wiring” and burying the wire from an A.C. power outlet (indoors) power supply to the detached garage. Then use a 12 volt to 5 volt micro-USB regulator adapter and install a V3 with spotlight.
The V3 will have better results and can be configured to trigger spotlight and siren on motion, plus you won’t be dealing with taking down to charge and putting back up.
The power Supply mounts indoors but the cable to camera can be longer as the 5 volts is regulated at the camera.
I have ran over 180 feet of 2 conductor cable to camera with this setup, use low voltage lighting wiring it can be buried, it is weatherproof and UV resistant.
Connect the 12v to 5v micro-USB regulator adapter to cable matching polarity ( +red -black ) along cable where a camera is needed if more than 1 camera just get a 12 volt adapter with more current (Amps) The Adapter regulator is weatherproof except the micro-USB itself but the boot on the V3 takes care of that.
12 volt input to 5 volt output micro-USB cable (adapter)
12 volt power supply 1 amp with connector adapter
14/2 Low Voltage Landscape Wire - 100 feet
This location originally had a V2 in an enclosure, the 12v to 5v adapter has been exposed to rain, snow, and heat of summer for over 2 years. Recently replaced V2 with a V3
Below is an event captured by this camera, note I don’t use IR as I get too many flying bug triggers.