In Rules it would be nice if you could add a duration/time delay for each Action in the list. For example lets say I set up a rule for when my outdoor cam senses motion to then do the following actions:
- Turn on bulb for duration X seconds.
- Turn off bulb for duration X seconds.
- Turn on bulb for duration X seconds.
- Turn off bulb for duration X seconds.
- Turn on bulb for duration X seconds.
- Set bulb brightness to full for duration X seconds (it would take X seconds to go from current brightness to full brightness).
- Set bulb brightness to min for duration X seconds.
- Turn bulb off.
The above action would cause the bulb to turn off and on, and then pulse. Currently if I do the above without durations it cycles through them like in a fraction of a second.
MODERATOR NOTE:
Your submission has been merged (see below). Please hop on over there and VOTE for it. For your vote to count, you must click the VOTE button at the top of the page.